We have collected the most relevant information on Xbee Send Audio. Open the URLs, which are collected below, and you will find all the info you are interested in.
How to make audio transmit over xbee pro s2b? - Digi …
https://www.digi.com/support/forum/45933/how-to-make-audio-transmit-over-xbee-pro-s2b
The XBee modules do not have the ability to transmit Analog Voice signals. You would need to use something like a board of education for both sides and have it convert the analog voice signals to serial data. Then use the XBee 802.15.4 modules to transmit that serial data between the two device. The receiving board of education would convert the serial data …
Voice transmission with Arduino + XBee - Audio - Arduino Forum
https://forum.arduino.cc/t/voice-transmission-with-arduino-xbee/51093
If you just want the raw values sent over, hook aud to an analog pin, and then send the analogRead value of that over xbee constantly. Then have the target device use PWM to send this to a speaker. Of course, I don't think that this mic picks up sound. It just does levels of sound. (I'll need confirmation on that.)
¿can I send a analog audio whit the XBee-PRO stand …
https://www.digi.com/support/forum/10452/can-send-analog-audio-whit-the-xbee-pro-stand-alone-802-modem
I have a radio receptor and I want to send the audio to my PC using the XBee-PRO stand-alone 802.15.4 RF modem ¿it is posible? the band wide of the audio is 3 KHz. thank you for any tips that you can give to me. asked Aug 14, 2010 in Device Manager by laah80 New to the Community (0 points)
arduino - How to send data to specific xbee end device ...
https://stackoverflow.com/questions/36643354/how-to-send-data-to-specific-xbee-end-device-from-a-coordinator-in-at-mode
You would need to go into command mode (don't send data for 1 second, send "+++", wait 1 second) and set ATDH and ATDL to the MAC address of the target device. Since all XBee modules have the same ATDH value, you'd only need to …
XBee variable send and receive - Programming Questions ...
https://forum.arduino.cc/t/xbee-variable-send-and-receive/147350
[u]After [/u] you have a payload to be sent, you need to create an instance of the Tx16Request class to send the data.
Now you know Xbee Send Audio
Now that you know Xbee Send Audio, we suggest that you familiarize yourself with information on similar questions.
