We have collected the most relevant information on Vs1000 Audio Module Arduino. Open the URLs, which are collected below, and you will find all the info you are interested in.
Got a VLSI VS1000 Audio Module working ... - Arduino Forum
https://forum.arduino.cc/t/got-a-vlsi-vs1000-audio-module-working-with-serial-control/171294
I went with 5V external power, it can take up to 6V VCC. Running from Arduino, power went down to 4.75V which works too. The module has a 3.3V regulated output and a 3.6V power-out pin as well that us used on the MAX232 control schematic to power the MAX232 but can probably power a small AVR if you don't milk it.
VS1000 Module Datasheet - VLSI
http://www.vlsi.fi/fileadmin/modules/vs1000mod.pdf
VS1000 Audio Module 3 PLACEMENT AND PINOUT 3 Placement and Pinout Figure 1: Pinout. Pin Name Description Pin Name Description 1 XRESET Active Low reset for VS1000 32 VCC Input Voltage. Power supply for the board. 3.6V - 6.0V al-lowed 2 D0 General purpose I/O pin 31 DVDD Output of DVDD regulator, for external circuitry
VS1000 Modules - VLSI Solution Webstore
https://webstore.vlsi.fi/Modules/VS1000-Modules
It works with Simple DSP Boards, Prototyping Boards, VS1053 USB Hi-Fi Player Board, VS1003 SD Card mini player, VS1000D Button-Cell Player, VS1000C Audio Module, and other boards with only logic-level RX / TX signals. It is not needed for VS1000 Developer Board and VS10xx/VS1053 Evaluation Kit because these already have RS232 interface. 25.00
VLSI Solution-VS1000 Audio Module
http://www.vlsi.fi/en/products/vsmd001.html
The module supports all options and the decision between micro-SD card, 2MB flash and 16MB flash is left to the customer. Interfacing with the host has been made very simple. Six wire connection (VCC, GND, RX, TX, LOUT, ROUT) is all that is typically needed to start audio. The module supports separate pins for headphone and line out.
VS1000 Audio Module Step-by-Step - Page 5 - VSDSP Forum
http://vsdsp-forum.com/phpbb/viewtopic.php?t=461&start=40
Re: VS1000 Audio Module Step-by-Step Post by pasi » Thu 2017-03-23 9:31 It might be a protection issue and the copy command is …
VS1000 Audio Module Step-by-Step - Page 2 - VSDSP Forum
http://www.vsdsp-forum.com/phpbb/viewtopic.php?t=461&start=10
Re: VS1000 Audio Module Step-by-Step. 1. To change the default startup volume, see the start of main () in usbmass.c and change the value assigned to player.volume . 2. For random play, look at the code after the playloop: label in spiplayer.c and sdplayer.c, and where player.currentFile is assigned. sdplayer.c has random play code, enable it ...
Now you know Vs1000 Audio Module Arduino
Now that you know Vs1000 Audio Module Arduino, we suggest that you familiarize yourself with information on similar questions.
