Volumeicon Pulseaudio | Audio-Digital.net

We have collected the most relevant information on Volumeicon Pulseaudio. Open the URLs, which are collected below, and you will find all the info you are interested in.

audio - Volume icon for PulseAudio on Tint2 -- nothing ...

https://unix.stackexchange.com/questions/356413/volume-icon-for-pulseaudio-on-tint2-nothing-works

# Executor 1 execp = new execp_command = volumeicon execp_interval = 0 execp_has_icon = 1 execp_cache_icon = 0 execp_continuous = 0 Save the file $HOME/.config/tint2/tint2rc Update the running tint2 with " sudo killall -SIGUSR1 tint2 " start tint2conf GUI, and go to "panel items" and add the "Executor" that has been created and apply …

Overview of pulseaudio volume control or pavucontrol ...

https://arcolinux.com/overview-of-pulseaudio-volume-control-or-pavucontrol-showcase-musicplayers-and-tips/

Pavucontrol stands for Pulse Audio Volume Control. We need to set the channels just right to enjoy our music and videos. CTRL + ALT + U is your keyboard shortcut. You install it with pacman, if you are on Arch Linux. ArcoLinux will have it always on board. Depending on your hardware you need to set the devices and their channels the right way.

pulseaudio & volumio — edunham

https://edunham.net/2020/05/30/pulseaudio_on_volumio.html

Volumio as a pulseaudio output. For awhile, my laptop was able to treat Volumio as just another output device, based on the following setup: the package pulseaudio-module-zeroconf was installed on the pi and on every laptop that wants to output audio through the living room speakers; the lines load-module module-zeroconf-publish and load-module module-native …

Volume Icon - nullwise

http://nullwise.com/volumeicon.html

volumeicon-0.5.1.tar.gz Volume Icon Volume Icon aims to be a lightweight volume control that sits in your systray. It is often used in conjuction with the lightweight tint2panel/taskbar. Features Change volume by scrolling on the systray icon Ability to choose which channel to control Several icon themes (with gtk theme as default)

volumeicon is killed immediately at start up if pipewire ...

https://bbs.archlinux.org/viewtopic.php?id=272890

For the volumeicon line use this: volumeicon > ~/vicon.log 2>&1 & Then check ~/vicon.log when it fails to start. Note that you should only fork () commands if needed. Unnecessary use of '&' can lead to race conditions and weird problems so you should probably remove that from the run function and only add it to the lines that need it.

Now you know Volumeicon Pulseaudio