Pulseaudio Setup Gentoo

PulseAudio - Gentoo Wiki

https://wiki.gentoo.org/wiki/PulseAudio

Gentoo Forums :: View topic - Pulseaudio - How to get it ...

https://forums.gentoo.org/viewtopic-p-6585449.html

So, I did my Gentoo installation as allways, but this time I tried to install pulseaudio. As soon as my system was working, everything is fine. But when I followed up Gentoo's wiki to install Pulseaudio (which I will need), and had to reboot after a WINE freeze, my audio device was messed up. I can hear sounds well, but I can't input audio.

pulseaudio – Gentoo Packages

https://packages.gentoo.org/useflags/pulseaudio

Enables PulseAudio sound driver that should be able to support positional event sounds. This is the preferred choice for best sound events experience and picked by default if compiled in and possible to use at runtime. app-emulation/qemu: Enable pulseaudio output for sound emulation: gui-apps/waybar: Enable support for volume control via PulseAudio

Gentoo Forums :: View topic - Pulseaudio --> Pipewire ...

https://forums.gentoo.org/viewtopic-p-8582157.html

Posted: Wed Mar 03, 2021 6:06 am Post subject: Pulseaudio --> Pipewire setup issues. Hi! I am trying to convert from Pulseaudio to Pipewire. My system is using sddm + kde + X and OpenRC.When I run `pactl info` I get the following message: Code: …

Getting DTS 5.1+ sound via S/PDIF or HDMI using PulseAudio ...

https://blogs.gentoo.org/mgorny/2021/07/25/getting-dts-5-1-sound-via-s-pdif-or-hdmi-using-pulseaudio/

If you’re using pavucontrol, the relevant checkboxes can be found on Output Devices tab, hidden under Advanced. Tick off all that your connected device supports (usually all). Finally, you have to enable S/PDIF passthrough (the same option is used for HDMI) in mpv, via ~/.config/mpv/mpv.conf: audio-spdif=ac3,dts,eac3 audio-channels=5.1.

Talk:PulseAudio - Gentoo Wiki

https://wiki.gentoo.org/wiki/Talk:PulseAudio