We have collected the most relevant information on Pulseaudio Playback Microphone. Open the URLs, which are collected below, and you will find all the info you are interested in.
pulseaudio - System sound playback is heard in …
https://askubuntu.com/questions/1204537/system-sound-playback-is-heard-in-microphone-channel
When I do a recording of my microphone is also contains all system playback. The sound settings dialog that displays the microphone input level live shows a full input level when I do the "Test" dialog on Output ("Front left/right"). The physical microphone is turned off/disconnected during this test.
pulseaudio - How to route pulse audio device into alsa ...
https://askubuntu.com/questions/895216/how-to-route-pulse-audio-device-into-alsa-loopback-virtual-microphone
So, the task now is: How to have pulseaudio select the device #1 of the loopback card for playback? Assuming the values from above, you may modify /etc/pulse/default.pa to read . . ### Load audio drivers statically ### (it's probably better to not load these drivers manually, but instead ### use module-udev-detect -- see below -- for doing this ...
pulseaudio - How to use microphone on headset in Ubuntu 16 ...
https://unix.stackexchange.com/questions/575357/how-to-use-microphone-on-headset-in-ubuntu-16-04
I have installed PulseAudio Volume Control. But it doesn't show up in the input devices section. Edit : I want the system to detect it as a headset rather than a headphone. Here's the screenshot of PulseAudio Here's the input device list. …
Using Jack and PulseAudio to apply effects on your …
https://github.com/jeiks/jack_and_pulseaudio
Select "system->capture_1" on the left and "jack_rack" on the right and click Connect. Select "jack_rack->out_1" on the left and "PulseAudio JACK Source" on the right and click Connect. 8. Using some effects: On the jack-rackyou can press the plus sign and select various effects and also combine them.
linux - Pipe/Mix Line In to Output in PulseAudio - Unix ...
https://unix.stackexchange.com/questions/263274/pipe-mix-line-in-to-output-in-pulseaudio
1. Load the loopback module pacmd load-module module-loopback latency_msec=5 creates a playback and a recording device. 2. Configure the devices in pavucontrol In pavucontrol, in the Recording tab, set the "Loopback" device's from input device to the device which receives the line in signal.
PulseAudio/Examples - ArchWiki - Arch Linux
https://wiki.archlinux.org/title/PulseAudio/Examples
Restart PulseAudio, run pavucontrol and select the "Output Devices" tab. Three settings should be displayed: Internal Audio Digital Stereo (HDMI) Internal Audio Simultaneous output to Internal Audio Digital Stereo (HDMI), Internal Audio Now start a program that will use PulseAudio such as MPlayer, VLC, mpd, etc. and switch to the "Playback" tab.
Now you know Pulseaudio Playback Microphone
Now that you know Pulseaudio Playback Microphone, we suggest that you familiarize yourself with information on similar questions.
