We have collected the most relevant information on Pulseaudio Network Authentication. Open the URLs, which are collected below, and you will find all the info you are interested in.
PulseAudio Network Configuration, Raspberry Pi Server ...
https://andre.blaatschaap.be/2020/06/pulseaudio-network-configuration-raspberry-pi-server/
With the auth-ip-acl I set the access control list to allow only connection from my network. auth-anonymous=1 allows anonymous authentication, which disabled the need for sharing cookies. Finally, I add list=0.0.0.0, this makes sure it only listens on IPv4 addresses, as otherwise the raspberry pi server will show up twice in the network.
Pulseaudio over network - Stack Overflow
https://stackoverflow.com/questions/57433896/pulseaudio-over-network
I ran "paprefs" on the server: Go to Network Access -> Enable access to local sound devices (Also check both 'Allow discover' and 'Don't require authentication'). I copied the cookie files from server to client, and verified. ~/.config/pulse/cookie. I set up the 2 /etc/pulse/default.pa files, inserting my client node IP 192.168.66.124:
networking - How to set up PulseAudio remote properly …
https://unix.stackexchange.com/questions/470961/how-to-set-up-pulseaudio-remote-properly-and-securely
Edit /etc/pulse/default.pa and add these lines: load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.0.0/24 auth-anonymous=1 load-module module-zeroconf-publish. Run these commands: pulseaudio -k pulseaudio --start pacmd list-modules | grep native-protocol-tcp pacmd list-modules | grep zeroconf-publish.
PulseAudio/Examples - ArchWiki
https://wiki.archlinux.org/title/PulseAudio/Examples
Go to Network Access -> Enable access to local sound devices (Also check both 'Allow discover' and 'Don't require authentication'). On the client: $ export PULSE_SERVER=server.ip && mplayer test.mp3 Using RTP/UDP instead of native-protocol-tcp
Using PulseAudio as network sound server on Ubuntu and ...
https://www.techytalk.info/pulseaudio-network-sound-server/
Press Alt+F2 and enter "paprefs" into the "Run Application" dialog. Here are the options you should check inside "Network Access" tab inside "paprefs" interface: After you are finished with "Network Access" tab", switch to "Network Server" tab and enable "Enable network access to local sound devices" option.
Configuring Pulse-audio to use a remote server – Rotelok ...
https://rotelok.com/configuring-pulse-audio-to-use-a-remote-server/
Or a more secure approach is authentication with pulse-cookie and IP address or Network, if you have multiple clientes you just need to input a list separated by a semicolon: load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;<CLIENT_IP_OR_CLIENT_NETWORK> On the client side, you can test your server configuration with the following:
PulseAudio: Sound over the network | manurevah
https://manurevah.com/blah/en/p/PulseAudio-Sound-over-the-network
Tell PulseAudio to listen (lolpunhaha) to network connections by adding the following 2 lines to /etc/pulse/system.pa (adjust the subnet to whatever you need): load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.0.0/24 load …
Now you know Pulseaudio Network Authentication
Now that you know Pulseaudio Network Authentication, we suggest that you familiarize yourself with information on similar questions.
