Pulseaudio Multicast Rtp

How to listen to the pulseaudio RTP Stream - freedesktop.org

https://freedesktop.org/wiki/Software/PulseAudio/Documentation/User/Network/RTP/

The multicast address (in my case 224.0.0.56) The multicast port (in my case 46454) Play it using mplayer. From the pulseaudio-discuss mailing list: mplayer -demuxer rawaudio -rawaudio channels=2:rate=44100:samplesize=2:format=0x10001 rtp://[addr]:[port]

audio - Is Pulseaudio able to receive RTP Multicast from ...

https://unix.stackexchange.com/questions/392728/is-pulseaudio-able-to-receive-rtp-multicast-from-any-source

I am not sure what exactly you tried (you didn't specify), but I can get two pulseaudio servers to communicate via multicast RTP in the following way. On the sender, pacmd load-module module-rtp-send source=name_of_mic_source destination_ip=232.43.211.230 inhibit_auto_suspend=always. where name_of_mic_source is a source connected to a ...

networking - PulseAudio RTP Multicast - how to synchronize ...

https://unix.stackexchange.com/questions/471229/pulseaudio-rtp-multicast-how-to-synchronize-audio-on-all-receivers

Is Pulseaudio able to receive RTP Multicast from any source? 1. Audio from headphones very low with Pulseaudio. 3. PulseAudio RTP - how to play sound on sender too? 2. PulseAudio RTP unicast poor sound quality - frequent pops. 2. How to check if someone is streaming RTP over a specific Multicast address?

Use Pulseaudio to stream audio file to network via RTP ...

https://gist.github.com/porjo/5cce51d80b349b984d5e8c1c95066c1a

sound - Multiple pulseaudio multicast "channels" - Ask …

https://askubuntu.com/questions/288661/multiple-pulseaudio-multicast-channels

How to Stream Audio to Raspberry Pi via PulseAudio RTP ...

https://stackoverflow.com/questions/57451900/how-to-stream-audio-to-raspberry-pi-via-pulseaudio-rtp-unicast