Nslu2 Audio Usb

Cisco-Linksys Storage Link for USB 2.0 Disk Drives NSLU2

https://www.amazon.com/Cisco-Linksys-Storage-Link-Drives-NSLU2/dp/B0001FSCZO

NSLU2: The Ultimate Device - Home

http://nslu2ultimate.weebly.com/

The NSLU2 (Network Storage Link for USB 2.0 Disk Drives) is a Network-attached storage (NAS) device made by Linksys introduced in 2004 and discontinued in 2008. It makes USB Flash memory and hard disks accessible over a network using the SMB protocol (also known as Windows file sharing or CIFS). It was superseded mainly by the NAS200 (enclosure

Network Storage Link for USB 2.0 Disk Drives

https://downloads.linksys.com/downloads/userguide/1224638671601/NSLU2_V10_UG_D-WEB.pdf

Wireless Home Music Broadcasting—Modifying …

https://www.linuxjournal.com/article/8595

NSLU2 [IAmNotA HomePage]

http://www.iamnota.net/doku.php?id=hw:nslu2

NSLU2. I have two Linksys NSLU2 Network Storage Link USB2 devices, one of which I've modified so far to use the internal serial port and de-underclocked to run at 266MHz. I'm using the OpenSlug firmware, which is a clean install of a bare-bones linux system on the slug. No part of the original Linksys code remains except for the bootloader ...

Slug USB Audio – Ultra High

https://ultrahigh.org/2007/03/slug-usb-audio/

After looking at the advice on nslu2-linux.org I picked up a super-cheap usb dongle from eBay. It’s the green one with the text "3D sound" on the side. This one is identified as being made by Tenx Technology, with USB ids 1130:f211. It works with the snd-usb-audio driver; Amplifier/Reciever/Speakers etc – you need to play the audio through speakers.

how to install netbsd on the linksys nslu2 (slug) without ...

https://wiki.netbsd.org/tutorials/how_to_install_netbsd_on_the_linksys_nslu2___40__slug__41___without_a_serial_port__44___using_nfs_and_telnet/

$ ./build.sh -u -U -m evbarm -a armeb -V KERNEL_SETS=NSLU2_AUDIO release Boot the kernel. Use tftp to load the kernel as described in the link above. You should see the following lines (or something similar) in your dmesg or console output. The …