We have collected the most relevant information on Lowest Noise Audio Jfet. Open the URLs, which are collected below, and you will find all the info you are interested in.


Simple JFET Audio Preamps - Ciphers By Ritter

    http://www.ciphersbyritter.com/RADELECT/PREJFET/JFETPRE.HTM#:~:text=The%20best%20JFET%20current%20for%20lowest%20noise%20can,gain%20we%20can%20expect%20from%20the%20second%20transistor.
    none

Low Noise High Gain - JFET - InterFET

    https://www.interfet.com/low-noise-high-gain/
    12 rows

Amplify small signals in low-noise circuit with discrete JFET

    https://www.planetanalog.com/amplify-small-signals-in-low-noise-circuit-with-discrete-jfet/
    The clean roll-off at the corner frequencies provides a natural-sounding filter for audio signals without sounding abrupt at the low and high ends. This closed-loop solution also offers very low input-referred noise of 1.99 …

Lowest Noise JFETs? | diyAudio

    https://www.diyaudio.com/community/threads/lowest-noise-jfets.317639/
    The low noise was a surprising gift. The device was intended for, and spec'd for, preamplifiers in the MF to HF range. A JFET that is low noise at RF frequencies isn't necessarily low noise at audio frequencies. Unfortunately there was never anything like a complementary device for the BF862.

Low-Noise JFETs Ð Superior Performance to Bipolars

    https://www.vishay.com/docs/70599/70599.pdf
    Low-Noise JFETs Ð Superior Performance to Bipolars Introduction Junction field effect transistors continue to outperform the best bipolar transistors on low-frequency noise at source impedances as low as 5 k . With higher source impedances, common in sensitive transducers, the JFET amplifiers exhibit dramatically lower noise figures.

Linear Systems Ultra-Low-Noise JFETs

    https://www.linearsystems.com/product-spotlight.html
    This line of ultra-low-noise JFETs includes: The LSK389. The LSK389 is Linear Systems’ premier ultra-low-noise part. This monolithic, N-Channel dual JFET is available in four Idss grades and is used in a variety of ultra-high-end audio and sensor applications.

JFE150 Ultra-Low-Noise, Low-Gate-Current, Audio, N …

    https://www.ti.com/lit/gpn/JFE150
    JFE150 Ultra-Low-Noise, Low-Gate-Current, Audio, N-Channel JFET 1 Features • Ultra-low noise: – Voltage noise: • 0.8 nV/√Hz at 1 kHz, IDS = 5 mA • 0.9 nV/√Hz at 1 kHz, IDS = 2 mA – Current noise: 1.8 fA/√Hz at 1 kHz • Low gate current: 10 pA (max) • Low input capacitance: 24 pF at …

A very low-noise FET input amplifier - NIST

    https://tf.nist.gov/general/pdf/821.pdf
    A low-noise amplifier has been designed utilizing a Toshiba 2SK117 N channel J-FET' as the input device in a cascode' configuration. Noise measurements on this amplifier yield a low-frequency noise current of 0.25 fA/m and a voltage noise of less than 1.2 nV/m in the 500 Hz to 500 kHz region. Bloyet, Lepaisant, and Varoquaux3 suggest a figure

Simple JFET Audio Preamps - Ciphers By Ritter

    http://www.ciphersbyritter.com/RADELECT/PREJFET/JFETPRE.HTM
    Low Current: Typically under 2mA down to 0.5mA or less. High Input Impedance: JFET input. Low Output Impedance: Emitter-follower output. Low Noise: A single input transistor instead of a differential pair. Wide Bandwidth: Typically to 100kHz. Fixed Known Gain and Low Distortion: Here 30dB and set by feedback.

Ultra low noise amplifiers - JanasCard

    http://www.janascard.cz/PDF/Design%20of%20ultra%20low%20noise%20amplifiers.pdf
    very low noise IF9030 and IF3601 with noise density 0.5 and 0.3 nV/√Hz respectively and low 1/f corner, but they have large capacitances and they are quite expensive, so using more BF862 in parallel may be a better option. Fig. 4. shows an ultra-low noise amplifier with two JFETs 2SK170 with gain 100 and voltage noise density bellow 0.7nV/√Hz.

OPA165x Ultra-Low-Noise, Low-Distortion, FET-Input, …

    https://www.ti.com/lit/ds/symlink/opa1656.pdf
    The FET-input architecture achieves a low 2.9‑nV/√Hz voltage noise density and 6‑fA/√Hz current noise density, allowing for very-low noise performance in a wide variety of circuits. The high bandwidth and high open-loop-gain design of the OPA165x delivers a low distortion of 0.000035% (–129 dB) at 20 kHz, and improves audio signal fidelity across the full audio bandwidth.

Now you know Lowest Noise Audio Jfet

Now that you know Lowest Noise Audio Jfet, we suggest that you familiarize yourself with information on similar questions.