Log Taper Vs Audio Taper | Audio-Digital.net

We have collected the most relevant information on Log Taper Vs Audio Taper. Open the URLs, which are collected below, and you will find all the info you are interested in.

What's the difference between linear and audio tapers, and ...

https://electronics.stackexchange.com/questions/50218/whats-the-difference-between-linear-and-audio-tapers-and-why-should-i-care#:~:text=Very%20simply%2C%20with%20a%20linear%20taper%2C%20if%20you,more%20natural%20progression%20when%20used%20for%20volume%20control.

none

Potentiometers - log vs audio taper? | The Gear Page

https://www.thegearpage.net/board/index.php?threads/potentiometers-log-vs-audio-taper.1267578/

I've heard it said that "Audio" is 10% (i.e. 50% rotation yields 10% of the total resistance)....whereas, by comparison, "Log" indicates some other percentage other than 10%". If that were the case here, though, one would think that the supplier would say "I have 'audio' [thereby implying 10%] or I have 20% log or 30% log, etc."

Audio or linear taper pots? What’s the difference ...

https://www.hoaglandcustom.com/2017/05/15/hello-world/

We prefer linear taper pots in the tone position for the control that they give you. A slight bump in a linear taper pot will give you a slight signal increase. That same slight bump with an audio taper pot might give you a BIG signal increase. Also, our experience tells us that most players have audio taper pots in their volume positions.

Potentiometers: Audio vs. Linear Tapers - Jameco …

https://www.jameco.com/Jameco/workshop/circuitnotes/Potentiometers-audio-taper-vs-linear.html

In a linear taper the relative position is equal to the resistance ratio. For example, rotating the potentiometer to 50% will cause the pot to function at 50% of the maximum resistance. Linear tapers can be good for adjusting lighting through light dimmers or for motion control. Non-linear tapers are often referred to as a logarithmic or audio taper. These are most commonly used …

Audio Taper vs. Linear Taper (whats what) and Cap ...

https://forum.seymourduncan.com/forum/the-guitar-shop/168189-audio-taper-vs-linear-taper-whats-what-and-cap-questions

Choosing audio (log) vs. linear depends on what you will be using the pot for. You should always use audio pots for volume control, otherwise you will find that the volume does not change smoothly as you turn the pot up and down. With a linear taper pot, you will find that the volume increases slowly from 0 to about 60 or 70 percent, then ...

Now you know Log Taper Vs Audio Taper