We have collected the most relevant information on Jl Audio Amp Turns Off. Open the URLs, which are collected below, and you will find all the info you are interested in.
Amp in Protection - Basic Car Audio Electronics
http://www.bcae1.com/repairbasicsforbcae1/troubleshootingbasicsampinprotect.htm#:~:text=There%20are%20a%20few%20amps%20%28some%20JL%20Audio%29,amp%20to%20shut%20down%20for%20a%20short%20while.
HD Amplifier Troubleshooting Guide – JL Audio Help Center ...
https://jlaudio.zendesk.com/hc/en-us/articles/204374290-HD-Amplifier-Troubleshooting-Guide
Check to make sure there is +12V at the “Remote” connection of the amplifier. In some cases, the turn-on lead from the source unit is insufficient to turn on multiple devices and the use of a relay is required. To test for this problem, jump the “+12VDC” wire to the “Remote” terminal to see if the amplifier turns on.
JL amp problem: shutting Off at high vol... HELP!!! - NASIOC
https://forums.nasioc.com/forums/showthread.php?t=2156274
Turn amp gains to zero, turn off all boost/eq/loudness(if it has it and it's on) on both amp and HU... Play 1000hz tone on repeat... Turn HU up until a distinct change in output is herd, back off, make sure, back off slightly... Consider this HU MAX (for now at least) Now, playing the same tone at HU MAX on repeat and move to the amp (for mids)..
Amplifier Status LED Colors & What ... - JL Audio Help Center
https://jlaudio.zendesk.com/hc/en-us/articles/225606727-Amplifier-Status-LED-Colors-What-they-Represent
Amplifier is powered and functioning properly. At least 10v DC are detected. Red: Amplifier has reached its thermal limits. Advanced Rollback Protection engaged. Amber (Yellow) Low Impedance : Blue* Low voltage (Under 8v). Amplifier turns off at 8v DC and turns back on when 9v DC is detected.
JL Audio amp killing battery with engine off? | Car Audio ...
https://www.caraudio.com/threads/jl-audio-amp-killing-battery-with-engine-off.525026/
Problem is, my battery is dead if I don't drive the car for more than about 8 days. I did some tests with my meter and found that my JL Audio amp is drawing 5 mA even with the key out. The amp is using a remote turn-on but the LED is NOT on when the key is out. So the amp isn't running but still drawing some power.
Amp in Protection - Basic Car Audio Electronics
http://www.bcae1.com/repairbasicsforbcae1/troubleshootingbasicsampinprotect.htm
There are a few amps (some JL Audio) that will go into protect and none of the indicators change. This happens when the voltage drops too low when the amp is being driven hard with an insufficient power supply. Sometimes, a VERY brief drop in voltage (too short to be seen on a standard multimeter) will cause the amp to shut down for a short while.
amp turns on then immediately off | Tacoma World
https://www.tacomaworld.com/threads/amp-turns-on-then-immediately-off.137885/
amp turns on then immediately off. Discussion in 'Audio & Video' started by JoshLV, Feb 3, 2011. Post Reply. Page 1 of 2 1 2 ... Carling switches, my bed light mod, diff drop, Alpine IVA-W505, JL Audio C5 componets and coaxials, JL 300/4 and 250/1 amps and JL stealthbox, wheathertechs, avs vent visors, toyota bed x-tender, alcantara center ...
Now you know Jl Audio Amp Turns Off
Now that you know Jl Audio Amp Turns Off, we suggest that you familiarize yourself with information on similar questions.
