We have collected the most relevant information on Jl Audio 300/4 Low Ohm Light. Open the URLs, which are collected below, and you will find all the info you are interested in.
JL 300/4 Low Ohm Light? | DiyMobileAudio.com Car Stereo Forum
https://www.diymobileaudio.com/threads/jl-300-4-low-ohm-light.45087/
I believe they are rated from 1 to 4 ohms of resistance. ! If you connect a load higher than 4Ω nominal per channel in stereo mode (or 8Ω in bridged mode), power will drop by half with every doubling of impedance above 4Ω stereo / 8Ω mono. If you connect a load lower than 1.5Ω nominal per channel in stereo mode (or 3Ω in bridged mode, the ...
JL 300/4 with Low Ohms Light On - the12volt.com
https://www.the12volt.com/installbay/forum_posts.asp?tid=109564
JL 300/4 with Low Ohms Light On - Just wired everything up, all were wired correctly. Triple checked. Brand new rear speakers, brand new RCA's, fairly new front speakers etc etc... The amp currently has no speaker wires hooked up, no RCA's hooked up. Only power, ground and remote. With the three wir
Low Ohm Light Issue and fix for $9!! JL Audio Slash v2 …
https://www.youtube.com/watch?v=JbR9bcK-VOw
This is a rather lengthy video of the process i went through to try to fix my JL amp without having to send it to JL. Cost me $9 in parts.
JL Audio 300/4 Low impedance - Amplifiers - #1 Car Audio ...
https://www.stevemeadedesigns.com/board/topic/207306-jl-audio-3004-low-impedance/
I have a JL audio 300/4 I'm looking to install in my Cadillac with stock speakers for now. The front speakers seem to be as low as 1ohm. I know these amps can handle anything as low as 1.5 ohm's so does anyone if they're up for 1 ohm?
JL Audio Amp problem - the12volt.com
https://www.the12volt.com/installbay/forum_posts.asp?tid=32469
JL Audio Amp problem - I have a JL 300/4 amp i hooked it up and then the low ohm light lights up, and the sound comming out of the speakers is all choppy. does anyone know whats wrong with it? I hooked it up with out rcas and speakres hooked up and its the same. ...
Amplifier Status LED Colors & What ... - JL Audio Help Center
https://jlaudio.zendesk.com/hc/en-us/articles/225606727-Amplifier-Status-LED-Colors-What-they-Represent
LED COLOR. DESCRIPTION. Green. Amplifier is powered and functioning properly. At least 10v DC is detected. Red. Amplifier has reached its thermal limits or too low of an impedance detected. Output is muted until safe operating temperature detected. OR There is a short circuit, an audible "popping" noise might be heard.
Now you know Jl Audio 300/4 Low Ohm Light
Now that you know Jl Audio 300/4 Low Ohm Light, we suggest that you familiarize yourself with information on similar questions.
