We have collected the most relevant information on Elsinore Speaker Diyaudio. Open the URLs, which are collected below, and you will find all the info you are interested in.
Elsinore speaker kit | diyAudio
https://www.diyaudio.com/community/threads/elsinore-speaker-kit.343813/
For sale a complete set of drive units for the Elsinore loudspeaker. Eight SB17NRXC35-8 mid bass drivers. Two Scanspeak Discovery D2608/9130.00 tweeters. All units are new and unused. Buying them would set you back around € 600. I offer the set for € 400.
The "Elsinore Project" Thread | Page 6 | diyAudio
https://www.diyaudio.com/community/threads/the-elsinore-project-thread.97043/page-6
I'm building too the Elsinore speaker, now I'm cutting the wood. And I did a mistake in the hole for the tweeter, it isn't a circle I didn't used the blade suitable for doing circular cuts and it was hard to get the blade in the direction I wanted. The hole diameter is 80-82mm.
The "Elsinore Project" Thread | Page 28 | diyAudio
https://www.diyaudio.com/community/threads/the-elsinore-project-thread.97043/page-28
Normally we would connect the drivers in parallel and get a 3-4 Ohm speaker. Yes, the voltage sensitivity would likely match the Elsinore, but the current required would quadruple, so efficiency is not improved, just a heavier load on the amp. I make no excuses for being in a particular camp (a minority one I would say). OK, over to you guys ...
The "Elsinore Project" Thread | Page 232 | diyAudio
https://www.diyaudio.com/community/threads/the-elsinore-project-thread.97043/page-232
The Elsinores achieve this with extra Sd with 4 drive units per speaker. Another approach to get low distortion in the 300Hz to 2khz band (as mentioned in the Purifi article) is to go 3 way. Taking the Elsinores as an example, the top …
The "Elsinore Project" Thread | Page 5 | diyAudio
https://www.diyaudio.com/community/threads/the-elsinore-project-thread.97043/page-5
As it is, the current series/parallel configuration of the Elsinores give you a nominal 8 Ohm load. If you parallel first before series, then you'd have to do a series crossover (Elsinores uses parallel crossover). I am afraid you are on your own and whatever you end up with, they won't be an Elsinore speaker. Joe R.
Now you know Elsinore Speaker Diyaudio
Now that you know Elsinore Speaker Diyaudio, we suggest that you familiarize yourself with information on similar questions.
