We have collected the most relevant information on Connecting Audio Equipment. Open the URLs, which are collected below, and you will find all the info you are interested in.
Connecting audio equipment - Audacity Manual
https://manual.audacityteam.org/man/connecting_audio_equipment.html
To connect a mixer to the line input port on your computer you will need a dual-RCA to mini-plug (1/8 inch) cable. Plug the RCA plugs into the RCA output jacks on the back of the mixer. Plug the stereo mini-plug into the line input port on your computer.
3 Ways to Connect Audio Devices to Computers - wikiHow
https://www.wikihow.com/Connect-Audio-Devices-to-Computers
Connecting your Equipment - Audacity Wiki
https://wiki.audacityteam.org/wiki/Connecting_your_Equipment
There are several types of plugs and sockets used for audio signals. The following list of connections should help with picking the correct lead in each case. The main types in use are, in approximate order of popularity: RCA Phono 1/4 inch (6.35 mm) jack/TRS (tip-ring-sleeve) 1/8 inch (3.5 mm) jack/TRS (tip-ring-sleeve) 2 pin DIN
The Ultimate Guide to Audio Connectors and Cables ...
https://www.audiostance.com/audio-connectors-and-cables/
The RCA connector is most commonly used in HiFi systems and other home audio equipment. It is an unbalanced, mono connector that you’ll also find on DJ mixers. RCA connectors are made up of 2 connectors, one for left side audio, and the other for the right. They’re commonly found in the colors of red and white, but this is not always the case.
Connect Your Sound Equipment to Your Computer - …
https://visihow.com/Connect_Your_Sound_Equipment_to_Your_Computer
Click the input ("Recording" tab) devices (usually called "Line-in"). Click "Properties". Click "Advanced". Set the same values as in "Playback". If the recording device bit/Hz properties are missing (mostly for onboard or built-in cards), then just ignore it. You will set it up in the recording software. Was this step helpful?
TO YOUR MIXER CONNECTING EQUIPMENT - Audio Minds
http://www.audiominds.com/training/manual/connections.pdf
Connect signal processors, such as compressors to the insert jack using a special insert ÔYÕ cable. This allows the signal to be sent and returned to the mixer using only one connector. Refer to section 7 for wiring information. It is also possible to connect the processor to the console without using the insert jacks by connecting an instrument direct
The ultimate guide to audio connections - SoundGuys
https://soundguys.com/the-ultimate-guide-to-audio-connections-24012/
You can connect via Bluetooth or use the included 3.5mm cable for wired listening and optimal audio quality. If you don’t want any wires on your headphones, then you basically have to go with Bluetooth.
How to Connect a Stereo System | Stereo Barn
http://stereobarn.com/how-to-connect-a-stereo-system1/
Based on the equipment you described, here’s my advice on how to hook it up: 1. Connect the KT-87 tuner to the KC-207 control amplifier. Use an analog stereo cable (the red and white type) from the tuner’s “Output” into the controller’s “Tuner” input. It should be labelled just like the inputs for “CD” or “Tape” would.
Now you know Connecting Audio Equipment
Now that you know Connecting Audio Equipment, we suggest that you familiarize yourself with information on similar questions.
