We have collected the most relevant information on Commodore 64 Audio Input. Open the URLs, which are collected below, and you will find all the info you are interested in.
Readers' Feedback: Commodore 64 Audio Input
https://www.atarimagazines.com/compute/issue54/102_1_READERS_FEEDBACK_Commodore_64_Audio_Input.php
You can test this by feeding the sound output of another 64 into the audio input. When mixing in another audio source, be sure it's at the same low level as SID chip output. (Feeding in an amplified signal could destroy your SID chip.) Intended for chaining SID chips together, the audio input becomes a kind of fourth voice, and is affected by the SID chip's volume and filter …
Commodore 64 audio input modification - Load tape games ...
https://www.aussiearcade.com/topic/54989-commodore-64-audio-input-modification-load-tape-games-using-a-ipodiphonemedplayer/
C64 Datasette 1 x 100Kohm resistor 1 x 3.5mm mono audio jack or old headphones you can destroy for the project Speaker wire if not using old headphone PC motherboard speaker (Optional) 1 x 100nf capacitor (Optional) First we …
A/V Jack - C64-Wiki
https://www.c64-wiki.com/wiki/A/V_jack
AUDIO IN: audio input This audio input (maximum 3 volts) is connected to the audio input (pin 26) of the SID sound chip. This signal is routed through the SID filters and/or output stage, depending on the programming. It is then put out together with the internally generated voices through the volume regulation of the SID on the audio output.
Commodore 64 Programmers Reference Manual
https://www.commodore.ca/manuals/c64_programmers_reference/c64-programmers_reference_guide-06-input_output_guide.pdf
The INPUT# statement works like the regular INPUTstatemel'lt. When typing data into the INPUT statement, the. data items are separated,.either by hitting,the .:I:aIIl:I~. key or using commas to separate them. The PRINT# statemel'lt puts a RETURN .at the end of a line just like the,PRINT statement. A$ fills up with all three values because there's no "," :
For Newbies - C64 Video output explained - Commodore 64 ...
https://www.lemon64.com/forum/viewtopic.php?t=72807
In these cables, white is the only Audio cable since the C64 is mono, Yellow is Luma and Red is Chroma. If you want to use your C64 with a more modern TV or monitor that has S-Video input, you need to buy or build a special cable that connects the corresponding Chroma and Luma pins to the standard 4-pin Mini DIN used in the S-Video Standard.
Now you know Commodore 64 Audio Input
Now that you know Commodore 64 Audio Input, we suggest that you familiarize yourself with information on similar questions.
