We have collected the most relevant information on C Audio Sr707 Power Amplifier. Open the URLs, which are collected below, and you will find all the info you are interested in.

C-Audio SR707 Stereo Power Amplifier Manual | HiFi Engine

    Power output: 488 watts per channel into 8Ω (stereo), 1653 watts into 8Ω (mono) Frequency response: 5Hz to 50kHz. Total harmonic distortion: 0.05%. Damping factor: 700. Signal to noise ratio: 100dB. Speaker load impedance: 2Ω (minimum) Dimensions: 482 x 133 x …

Dual-Channel Power Amp C Audio SR 707 - Audiofanzine

    Manufacturer: C Audio. Model: SR 707. Category: Dual-Channel Power Amps. Added in our database on: 10/28/2008. We have no technical specifications for this product. but your help will be much welcomed.

C Audio SR707 Power Amplifier - Blue Room technical forum

    C22 and C17 are there to make the amplifier stable. IN other words, if you mess with their value you will turn the SR707 from being an amplifier into a power oscillator. This is generally considered 'A Bad Thing' ™ and is sure to fry all your HF speakers. Likewise the resistor near R51 also has little effect in the audio band.

SR707 - Asystems SYS

    SR707. 700 Watt Power Amplifier Output power per channel: 350W @ 70V or 100V Low impedance output (2 ohms): 550W per channel

C-Audio SR-707 Protect Issue - Speakerplans.com Forums ...

    Quote Reply Topic: C-Audio SR-707 Protect Issue Posted: 01 March 2019 at 6:28am: Hello. I have a power amplifier C-Audio Sr707. The protect LED comes on when turning on it on. The fans come on too. but it does not amplify. it all looks clean inside, the glass fuse inside is o.k. I wonder does anybody know what the fault might be? Could it be a ...

SCHEMATICS FOR C-AUDIO SR606 AND 707 - Tom's Guide Forum

    I've got 2 c-audio power amp. 1 c-audio sr404 fully upgraded to a sr707, and 1 sr606. Both of them are now not working, and i'm searching for schematics to recover them. Can you help me? Thanks a lot, Maurizio

How to set bias for this amplifier - diyAudio

    Hi, recently I build a C Audio SR707 amplifier using the schematic diagram. Outputs are Fet's and drivers are C5200 and A1943. ( originals are different ) My question is positive side driver is getting hot even thers is no signal . with in few seconds of power on the + side driver gets hot .

Now you know C Audio Sr707 Power Amplifier

Now that you know C Audio Sr707 Power Amplifier, we suggest that you familiarize yourself with information on similar questions.