We have collected the most relevant information on Audiocodes Endpoint Phone Number Table. Open the URLs, which are collected below, and you will find all the info you are interested in.


Configuration Note - AudioCodes

    https://www.audiocodes.com/media/10181/ltrt-31902-audiocodes-mediant-1000-msbg-with-microsoft-lync-and-verizon-sip-trunk-configuration-note.pdf
    A.1 Step 1: Configure the Endpoint Phone Number Table..... 97 A.2 Step 2: Configure Tel to IP Routing Table..... 98 A.3 Step 3: Configure Coders Table..... 99

AudioCodes MP-102/104/108 - net2phone

    https://partner.net2phone.com/partnersupport/products/audiocodesmp/audiocodesmpconfigguide.pdf
    This table defines phone numbers associated for each of the endpoints. This value can be any alphanumeric string. NOTE Only set the phone number for the port that is being used. 1. Click Protocol Management on the left, and click Endpoint Phone Numbers. Endpoint Phone Number Table 2. In the Channel(s) and Phone Number columns, enter the following values,

AudioCodes CPE & Access Gateway Products

    https://www.audiocodes.com/media/9538/ltrt-09404-mp-124-dc-sip-fast-track-guide.pdf
    Open the ‘Endpoint Phone Number Table’ page (Configuration tab > VoIP menu > GWandIPtoIP> Hunt Group > Endpoint Phone Number). 2. In the ‘Channel(s)’ column, enter the port number of the FXS port that you want to enable. 3. In the ‘Phone Number’ column, enter the port’s phone number (e.g. 401, typically

AudioCodes MP114/118, v4.8 and higher - Zenitel Wiki

    https://wiki.zenitel.com/wiki/AudioCodes_MP114/118,_v4.8_and_higher
    The prefix code entered in the End Point Phone Number Table will be shown together with the text in Caller ID/Name. If Caller ID name is detected on the FXO line, this will be used instead of the Caller ID name in the table above. Caller ID from FXO line must be enabled in Protocol Management > Advanced Parameters > Supplementary Services.

AudioCodes MP114/118, v5.4 and higher - Zenitel Wiki

    https://wiki.zenitel.com/wiki/AudioCodes_MP114/118,_v5.4_and_higher
    Endpoint Phone Number. In the ‘Endpoint Phone Number Table’ page the FXO lines are linked to the prefix in AlphaCom and to the hunt group ID. (Configuration tab > Protocol Configuration menu > Endpoint Number submenu > EndPoint Phone Number page item). In the example below all four FXO lines belong to Hunt Group ID 1.

Now you know Audiocodes Endpoint Phone Number Table

Now that you know Audiocodes Endpoint Phone Number Table, we suggest that you familiarize yourself with information on similar questions.