We have collected the most relevant information on Audio Sensing Power Switch. Open the URLs, which are collected below, and you will find all the info you are interested in.
Amazon.com: sound activated switch
https://www.amazon.com/sound-activated-switch/s?k=sound+activated+switch
Auto sensing on/off switch | diyAudio
https://www.diyaudio.com/community/threads/auto-sensing-on-off-switch.334994/
I am looking for a switch that senses the line-level audio signal, switches on an amplifier when there is a signal, and turns the amplifier off when there is no signal for a while. Yes, there is the Rod Elliot #38 circuit, which does exactly that ("Signal Detecting Auto Power-On Unit"). However, I am too lazy to make a PCB for it.
Automatic Load Sensing Power Switch - EEWeb
https://www.eeweb.com/automatic-load-sensing-power-switch/
Automatic Load Sensing Power Switch. Posted Tuesday, April 23, 2013. This circuit will automatically switch on several mains-powered “slave” loads when a “master” load is turned on. For example, it will switch on the amplifier and CD player in a stereo system when the receiver is turned on. It works by sensing the current draw of the “master” device through a low value …
Amazon.com: current sensing switch
https://www.amazon.com/current-sensing-switch/s?k=current+sensing+switch
Amazon.com: Niles APC2 Black (FG00254) Current …
https://www.amazon.com/Niles-FG00254-Current-Outlet-Switcher/dp/B00091UBCC
Three AC Outlets - One Current Sensing (requires Min. 30W Current Draw Differential Between On/off For Reliable Sensing), One Switched, One Unswitched 1,500W Maximum (all Outlets Combined) APC-2 Is Activated By Current Sensing Outlet Or 12Volt DC Signal (100mA Minimum) 12Volt Control Output for Activating Other Niles Audio Devices like SPK-1, AVS-2, AC-3, Or RFS …
Automatic Load Sensing Power Switch - Aaron Cake
https://www.aaroncake.net/circuits/loadswitch.asp
Automatic Load Sensing Power Switch Sunday, March 01, 2009 5:42:16 AM The values for 240VAC operation are R2 = 50K, 1W and R6 = 200K, 1W. these are calculated just using Ohms law by keeping the current at same level. if you want to increase the current then increase the wattage with same ratio, i.e doubling current will double the wattage of R2 and R6
Now you know Audio Sensing Power Switch
Now that you know Audio Sensing Power Switch, we suggest that you familiarize yourself with information on similar questions.
