Antec Sonata Audio Connector

K9N Platinum and Antec Sonata II: front audio connections ...

https://forum-en.msi.com/index.php?threads/k9n-platinum-and-antec-sonata-ii-front-audio-connections.99535/

1. Microphone Signal Pin: Connect the MIC connector to this pin. 2. Microphone Power: Connect the MIC-BIAS connector to this pin. 3. Ground Pin: Connect the AUD GND connector to this pin. 4. Front Right Speaker Out Pin: Connect the FPOUT-R connector to this pin. 5. Front Right Speaker Out Pin: Connect the FPOUT-L connector to this pin. 6.

Antec Sonata Front Panel Audio - Tom's Hardware Forum

https://forums.tomshardware.com/threads/antec-sonata-front-panel-audio.646465/

I attached the front panel audio connector on my Antec Sonata using the. standard 10-pin Intel connector on my Asus P4P800 motherboard. When I plug. in a set of speakers or headphones to the front...

Front Audio Connection On Antec Sonata | OCAU Forums

https://forums.overclockers.com.au/threads/front-audio-connection-on-antec-sonata.247680/

The front audio connectors were only in the front of my sonata for about 45 minutes (see here ), but my advice would be to make up an extension lead with a 3.5mm plug on the back, wired to the front audio ports (see the manual for the case for a diagram) and then loop it through a spare PCI slot to the back of the card.

Antec's Sonata ATX case - The Tech Report

https://techreport.com/review/6247/antecs-sonata-atx-case/

And for audio, Antec provides a connector with separate individual pins, plus a connector with the commonly used Intel-style pinout. As it should be. Making the Firewire port—err, IEEE1394 port,...

Downtown Doug Brown » Antec Sonata III front panel ...

https://www.downtowndougbrown.com/2012/01/antec-sonata-iii-front-panel-headphone-jack-usb-interference-fix/

The connector you plug into your motherboard for the front audio ports also has a ground pin on it. So your motherboard provides a ground for each of these connectors. The problem is that the front port assembly on my case connected the ground pins for the USB ports and the audio ports together on its end. This created a ground loop. My ...

SONATA III 500 - images10.newegg.com

/rebates/welcome?url=https%3a%2f%2fimages10.newegg.com%2fUploadFilesForNewegg%2fitemintelligence%2fAntec%2fSonataIII_manual_EN1453070227825.pdf&murl=https%3a%2f%2fclick.linksynergy.com%2fdeeplink%3fid%3dmsYS1Nvjv4c%26afsrc%3d1%26mid%3d44583%26murl%3dhttps%253a%252f%252fimages10.newegg.com%252fUploadFilesForNewegg%252fitemintelligence%252fAntec%252fSonataIII_manual_EN1453070227825.pdf%26u1%3d&id=newegg&name=Newegg&ra=1%&hash=b4fd1be0f7f0529995fab7044c9c7c1bcb2cfbcdea8a1dc306545e2bd747becd&network=Rakuten

Nine Hundred - Front Port Replacement - Antec America support

http://support.antec.com/support/solutions/articles/1000184694-nine-hundred-front-port-replacement-

Instructions: 1. Start by removing the left side panel from the chassis. 2. Disconnect the USB ports, Audio ports, and [if applicable] the firewire port from your motherboard. 3. Disconnect the top fan from your motherboard or power supply. 4. Locate and remove the two screws that secure the top panel to the chassis.