We have collected the most relevant information on 6146 Se Audio Circuits. Open the URLs, which are collected below, and you will find all the info you are interested in.


A Single 6146 Amplifier - QRO

    http://qro.it/amp/schemi/pdf/59hb196.pdf
    A Single 6146 Amplifier The photographs of Figs. 6-64, 6-67, and 6-68, show views of an amplifier using a single 6146. With the built-in supply shown, it can be operated at an imput of about 70 watts, or up to 90 watts with a 750-volt supply. The circuit is shown in Fig. 6-65. The input circuit is a conventional parallel-tuned tank with link ...

The AA8V 6146B Amplifier - Amplifier Schematic …

    https://www.frostburg.edu/personal/latta/ee/6146amp/schematic/6146schematic.html
    Plate Tank Circuit: The plate tank circuit is a pi-network that matches the high impedance of the plate to the low impedance of the antenna. At the same time the circuit filters out undesired harmonics from the output signal. The signal from the plate enters through the 1000 uuf plate coupling capacitor at the upper left in the schematic.

6146 based AM Transmitter (DETAIL page)

    https://www.mymorninglight.org/ham/6146.htm
    The mic preamp/audio driver is the only solid state portion of this whole transmitter! (It is the salvaged audio amp portion of a lightning-fried computer's sound card. BTN!!) It is capable of producing about 2 watts of audio, but only needs to push a few dozen milliwatts into the exciter to drive the modulator.

6146 Family of Vacuum Tubes | Amplified Parts

    https://www.amplifiedparts.com/tech-articles/6146-family-tubes
    In mid-1964 RCA introduced the 6146B with the "claim" of 33.33 percent higher power input than the 6146 / 6146A. Also, it was "claimed" that the 6146B could be directly substituted for the earlier tubes. The 6146 / 6146A had a maximum rated power input of 90 watts for CW and SSB operation and the 6146B had a rating of 120 watts for the same ...

Antique Radio Forums • View topic - 6146 for audio output ...

    https://www.antiqueradios.com/forums/viewtopic.php?t=60330
    Joined: Jan Thu 01, 1970 1:00 am. Posts: 28372. Location: Detroit, MI USA. IIRC it was RCA that built a theatre amplifier with P-P 6146's back in the 50's or early 60's, which was rated at something like 75 or 100 watts output. Like nearly any other beam power tube or pentode, they would make good audio output tubes provided you get the magic ...

Now you know 6146 Se Audio Circuits

Now that you know 6146 Se Audio Circuits, we suggest that you familiarize yourself with information on similar questions.